Supertex公司的HV9967是开环平均模式电流控制LED驱动器,集成了60V 0.8Ω MOSFET,可用作单独使用的降压转换器开关,LED电流精度3%,单个电阻设定LED电流,能和500V耗尽型MOSFET级联,主要应用在DC/DC或AC/DC LED驱动器,平板显示器的RGB背光,通用恒流源,信号和装饰LED照明以及充电器.本文介绍了HV9967主要特性,功能方框图, 典型应用电路图以及4W LED驱动器演示板主要指标, 电路图和材料清单.
4W LED Driver Demoboard with Accurate Average-Mode Constant Current Control
The HV9967 is an open loop average-mode current control LED driver IC operating in a constant off-time mode.
The IC features an integrated 60V 0.8Ω MOSFET that can be used as a stand-alone buck converter switch, or connected as a source driver output for driving an external high-voltage depletionmode MOSFET. The HV9967 is powered through its switching output when the integrated switch is off. Hence, the same external MOSFET can be used as a high-voltage linear regulator deriving the power supply voltage for powering the IC.
The LED current is programmed with one external resistor. The average-mode current control does not produce a peakto- average error, and therefore greatly improves accuracy, line and load regulation of the LED current without any need for loop compensation or direct sensing the LED current at a high-voltage potential. The auto-zero circuit allows the IC to cancel the effect of both the input offset voltage and the propagation delay in the current sense comparator.
The HV9967 features hiccup-mode short circuit protection and the over-temperature protection. A PWM dimming input is provided.

HV9967主要特性:
3% accurate LED current
Integrated 60V 0.8Ω MOSFET
Small outline MSOP-8 package
Low sensitivity to external component variation
Cascode connection with a 500V depletion-mode MOSFET
Single resistor LED current setting
Fixed off-time control
PWM dimming input
Output short circuit protection with skip mode
Over-temperature protection

HV9967应用:
DC/DC or AC/DC LED driver applications
RGB backlighting of flat panel displays
General purpose constant current source
Signage and decorative LED lighting
Chargers

图1.HV9967功能方框图

图2.HV9967典型应用电路图

图3.HV9967低压DC输入的典型应用电路图

4W LED驱动器演示板
4W LED Driver Demoboard with Accurate Average-Mode Constant Current Control
The HV9967DB1 demoboard is a high-brightness LED driver designed to drive 4 LEDs in series at currents up to 350mA from a 20 - 60V DC input. The demoboard uses the Supertex’s HV9967 in a buck configuration in a constant offtime mode.
The HV9967DB1 LED driver features tight regulation of the LED current within a few milliamps over the entire range of the input voltage (i.e. 20 - 60VDC). The LED current accuracy is almost insensitive to the passive component tolerances, such as the output filter inductance or the timing resistor.
PWM dimming can be achieved by applying a pulse-widthmodulated square wave signal between the PWMD and GND pins.

4W LED驱动器演示板指标:


图4.4W LED驱动器演示板外形图

图5.4W LED驱动器演示板电路图

4W LED驱动器演示板材料清单(BOM):